Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Code Block
+++xBoot Feb 14 2024 18:41:41
Remap DRAM for 4GB
ID1 of STI8070X = 0x88
ID2 of STI8070X = 0x01
Set PLLC to 1.5GHz
Set PLLL3 to 1.2GHz
PLLD: 800MHz, DATARATE:3200
0x00001008
0x0000C0BE
0x00000107
[d] xboot.c :397
..mode=0x0000001F

{{emmc_boot}}
[d] common/bootmain.c :76
dev=2
pin=1
.Run draiminit@0xFA208351
bootdevice=0x0000001F
Built at Feb 14 2024 18:41:37
dram_init
dwc_umctl2_lpddr4_1600_SP7350_for_realchip
MT53E1G32D2_B, 2rank, FBGA=D8CJG
SDRAM_SPEED_1600
dwc_ddrphy_phyinit_main 20231212
dwc_ddrphy_phyinit_out_lpddr4_train1d2d_3200_SP7350
bootdevice:0x0000001F
XBOOT_len=0x0000AEA0
1D IMEM checksum ok
1D DMEM checksum ok
Start to wait for the training firmware to complete v.00 !!!
End of CA training.
End of initialization.
End of read enable training.
End of fine write leveling.
End of read dq deskew training.
End of MPR read delay center optimization.
End of Wrtie leveling coarse delay.
End of write delay center optimization.
End of read delay center optimization.
End of max read latency training.
Training has run successfully.(firmware complete)
bootdevice:0x0000001F
2D IMEM checksum ok
2D DMEM checksum ok
Start to wait for the training firmware to complete v.00 !!!
End of initialization.
End of 2D write delay/voltage center optimization.
End of 2D write delay/voltage center optimization.
End of 2D read delay/voltage center optimization.
End of 2D read delay/voltage center optimization.
Training has run successfully.(firmware complete)
Register programming done!!!
Register programming done!!!
dram_init_end
Done draiminit
dram test 0x00800000 - 0x00800400
Set WL_REG_ON (GPIO56) to HI.
[d] sdmmc/drv_sd_mmc.c :21
InitChipCtrl
busclk=200000
div=1789
[d] sdmmc/drv_sd_mmc.c :23
IdentifyStorage
[d] sdmmc/hal_sd_mmc.c :507
busclk=25000000
div=14
[d] sdmmc/hal_sd_mmc.c :1729
[d] sdmmc/drv_sd_mmc.c :33
Read GPT
part1 LBA=0x00000022
emmc load uboot@blk=0x00000022
uboot1 hdr good
part2 LBA=0x00000822
emmc load uboot@blk=0x00000822
data size=858952
verify img...
uboot2 good
emmc load fip@blk=0x00001022
data size=408462
verify img...
uboot @0x00500040
fip @0x01000000
M4 init: 
32->64
a64up@0xFA218400
core0 S-EL3 @0x00200000

...