...
| Table of Contents | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Fastboot Over USB
To use the fastboot on SP7350 platform over USB interface, after successfully booting from the eMMC device and enter command-line interface of U-Boot, please follow the following steps.
Activate the USB Download Gadget
To establish a connection between your SP7350 platform and a Windows computer for USB downloads, please use the following command in the U-Boot command-line interface to activate the USB download gadget:
...
By executing these commands, you seamlessly enable the SP7350 platform to function as a USB download gadget, facilitating a smooth and efficient fastboot process.
Update USB Download Gadget Driver in the Windows Computer
Following the execution of the command in U-Boot and connecting the SP7350 platform to the Windows computer, you may observe that in the Device Manager, the USB is categorized under "Other devices" as "USB download gadget" in Windows. To update the driver, follow these steps:
...
After the update, you will see SAMSUNG Android Phone->Android ADB Interface in Device manager.
...
Install Minimal ADB and Fastboot on Windows Computer
To install the “Minimal ADB and Fastboot” application on your Windows computer, please follow these steps:
Download the Application: Obtain the “Minimal ADB and Fastboot” application and install it on your Windows computer.
Installation Path: During installation, the application is typically placed in the directory "c:\Program Files (x86)\Minimal ADB Fastboot."
Organize Image Files: Place the necessary image files (xboot.img, u-boot.img, uImage, and rootfs.img) in the installation folder. This is crucial for efficiently reflashing partitions using subsequent commands.
Flash Images
x-boot Partition
The image file of x-boot (xboot.img) is stored at boot partition 1 of eMMC device and its default target name is “mmc0boot0” as shown in menuconfig of U-Boot:
...
Upon execution, the system will report the maximum download size as 117,440,512 bytes. Subsequently, the 'mmc0boot0' target, with a file size of 131KB, will be sent and successfully written, completing the process in approximately 0.032 seconds.
u-boot, kernel or rootfs Partitions
The U-Boot command "mmc part" can be applied to retrieve the partition names within the eMMC's User Data Area Partition (GUID):
...
Upon execution, the system will process the update, indicating the maximum download size and confirming the successful transfer and writing of the u-boot image to the 'uboot2' partition. This process is analogous when updating the kernel or rootfs.
Fastboot Over Ethernet
Fastboot over Ethernet provides an alternative and efficient means of updating system images. To use the fastboot over Ethernet interface, please follow the following steps.
Enable UDP Support
To use fastboot over Ethernet, we need to enable “Enable fastboot protocol over UDP” in U-Boot. If it is not enabled, please enable it.
Navigate to the Device Drivers > Fastboot support.
Select "Enable fastboot protocol over UDP" as shown below:
...
...
Reference to the previous section “Update USB download gadget driver in the Windows computer.”
Install Minimal ADB and Fastboot on Windows Computer
Reference to the previous section “Install Minimal ADB and Fastboot on Windows computer.”
Configure Network Settings
To establish a connection between the SP7350 and the Windows computer via the Ethernet, please configure the Network Interface Card (NIC) settings for both devices.
...
Please also configure your Windows computer.
Establish UDP Connection for Fastboot
To establish a UDP connection of fastboot between your SP7350 platform and a Windows computer, please execute the following command:
| Code Block |
|---|
=> fastboot udp |
Flash Images
In the Windows Command Prompt, use the following command to update the x-boot image. Note that the process for updating u-boot, kernel, or rootfs is analogous:
...