...
| Field Name | Bit | Access | Description |
| Reserved | 15:8 | RW | RESERVED |
| TMDS_rst_b | 7 | RW | TMDS reset. 0 = reset, 1 = normal |
| Audio_rst_b | 6 | RW | Audio reset. 0 = reset, 1 = normal |
| Video_rst_b | 5 | RW | Video reset. 0 = reset, 1 = normal |
| RW afifo_lp_en | 4 | RW | Audio FIFO Low Power Enable. 0 = disable, 1 = enable |
| CEC_rst_b | 3 | RW | CEC reset. 0 = reset, 1 = normal |
| HDCP_rst_b | 2 | RW | HDCP Engine reset. 0 = reset, 1 = normal |
| FIFO_rst_b | 1 | RW | Audio FIFO reset. 0 = reset, 1 = normal |
| SW_ rst_b | 0 | RW | Software reset. 0 = reset, 1 = normal |
380.7 SYSTEM STATUS ( SYSTEM STATUS 0x7 )
Address: 0x9C00BE1C
...
| Field Name | Bit | Access | Description |
| Reserved | 15:4 | RW | ReservedRESERVED |
| tmds clkdetect | 3 | RU | TMDS clock detect. (Clock sources from TMDS PHY) 0 = No TMDS clock. 1 = TMDS clock exist |
| pll_ready | 2 | RU | Internal PLL ready. (for reference only) 0 = Not ready. 1 = Ready |
| hpd_in | 1 | RU | Hot Plug Detect status 0 = No Hot Plug. 1 = Hot Plug In (Usually means HDMI RX is connected) |
| rsen in | 0 | RU | HDMI RX sense 0 = No Rx. 1 = Rx active (HDMI RX is powered) |
...
| Field Name | Bit | Access | Description |
| ctl default | 15:12 | RW | CTL[3:0] Debug use. Do not alternate it. debug 的可以變成 Reserve 嗎 ? |
| Reserved | 11:3 | RW | ReservedRESERVED |
| null packet en | 2 | RW | Auto null packet enable 0: Disable NULL packet 1: Enable NULL packet |
| tmds dbus sel | 1 | RW | 30/60bits TMDS bus select. (Only for RD use) For RD use 的可以變成 Reserve 嗎 ? |
| hdmi mode | 0 | RW | HDMI mode or DVI mode. 0 = DVI mode. 1 = HDMI mode |
...
| Field Name | Bit | Access | Description |
| Reserved | 15:0 | RW | ReservedRESERVED |
380.10 SYSTEM CTRL2 ( SYSTEM CTRL2 -- 0xa )
Address: 0x9C00BE28
Reset: 0x0000
For RD use 的可以變成 Reserve 嗎 ?
| Field Name | Bit | Access | Description |
| Reserved | 15:3 | RW | ReservedRESERVED |
| tclkd2 edge | 2 | RW | tclkd2 edge select. (Only for RD use) For RD use 的可以變成 Reserve 嗎 ? |
| tst tclkd2 | 1 | RW | tclkd2 test. (Only for RD use) 0 = From TMDS. 1 = From pclkd2 |
| tst tclk | 0 | RW | tclk test. (Only for RD use) 0 = From TMDS. 1 = From pclk |
...
| Field Name | Bit | Access | Description |
| hpd deb delay | 15:0 | RW | Hot Plug Detection debounce counter. If HPD signal is unstable, try to increase this value |
...
| Field Name | Bit | Access | Description |
| ddc deb delay | 15:0 | RW | DDC signal debounce counter. If DDC signal is unstable, try to increase this value |
...
| Field Name | Bit | Access | Description |
| Reserved | 15:0 | RW | ReservedRESERVED |
380.14 RESERVED 000E ( RESERVED 000E -- 0xe )
Address: 0x9C00BE38
Reset: 0x0000
...
| Field Name | Bit | Access | Description |
| Reserved | 15:0 | RW | ReservedRESERVED |
380.15 SYSTEM CTRL5 ( SYSTEM CTRL5 -- 0xf )
Address: 0x9C00BE3C
Reset: 0x8000
這些應該可以改成 RESERVE
| Field Name | Bit | Access | Description |
| VIDEO PIN MX | 15 | RW | Useless, please do not modify it |
| CARBON ONLY MODE | 14 | RW | Useless, please do not modify it |
| Reserved | 13:11 | RW | Reserved |
| PCLK SRC SEL | 10 | RW | Useless, please do not modify it |
| PLLTV EN MODE | 9 | RW | Useless, please do not modify it |
| TMDSTX ONLY MODE | 8 | RW | Useless, please do not modify it |
| Reserved | 7:5 | RW | Reserved |
| DUMMY GPIO MODE | 4 | RW | Useless, please do not modify it |
| SW SCAN MODE | 3 | RW | Useless, please do not modify it |
| SW BIST MODE | 2 | RW | Useless, please do not modify it |
| CEC PROBE MODE | 1 | RW | Useless, please do not modify it |
| OTP PGM MODE | 0 | RW | Useless, please do not modify it |
...
| Field Name | Bit | Access | Description |
| Reserved | 15:12 | RW | Reserved |
| HDf_BKSV_error | 11 | RO | 全名 ? 1'b1: the BKSV value of HDMI receiver is error |
| RO HDf_AKSV_error | 10 | RO | 全名 ? 1 = the AKSV value of HDMI transmitter is error |
| HDf AKSV ready | 9 | RO | 全名 ? 1 = AKSV is ready in HDMI transmitter |
| HDt_R0_ready | 8 | RO | 全名 ? 1 = Ri is ready in HDMI transmitter |
| Reserved | 7:4 | RW | Reserved |
| FreeAn_gen | 3 | RO | 全名 ? 1 = The cipher engine is free running to generate AN |
| Repeater | 2 | RW | 全名 ? 1 = HDMI receiver is a Repeater |
| HDCP 1p1 Feature | 1 | RW | 全名 ? 1 = enable Bcaps bit 1.1 FEATURES |
| HDCP Encryption | 0 | RW | 全名 ? 1= enable HDCP encryption |
380.17 BKSV12 ( BKSV12 -- 0x11 )
Address: 0x9C00BE44
Reset: 0x0000
| Field Name | Bit | Access | Description |
| BKSV[15:0] | 15:0 | RW | the LSB BKSV [15:0]value of HDMI receiver (BKSV 是什麼的縮寫?) |
380.18 BKSV34 ( BKSV34 -- 0x12 )
Address: 0x9C00BE48
Reset: 0x0000
...